Roof waterproofing — for flat and pitched roofs

It is used for the formation of a finishing or intermediate waterproofing layer on roofs of various designs, including for operated flat roofs. It can be applied to concrete, mineral wool, foams of various brands. For the formation of a waterproofing layer on a hard base, the coating thickness is 0.5−1 cm, for the formation of a waterproofing layer on soft substrates (mineral wool, foams) The recommended layer thickness is 1.5−3 cm. Various decorative coatings can be applied to the formed layer — paint, tile, mosaic, stone, etc. In the case of forming an operational roof on a rigid base, the thickness of the coating layer should be at least 1 cm, when forming an operational roof on mineral wool with a density of 100, the thickness of the coating layer should be at least 3 cm.;see  It consists of two components#— a dry mixture of powder and liquid polymer. It is recommended for use in residential and office premises, preschool institutions, orphanages, educational and medical institutions.

Features: provides reliable waterproofing of junctions and exits of engineering units on roofs. The possibility of application on wet substrates. Increased adhesion to mineral and polymer surfaces. It does not soften in the sun, it does not crack in the cold. Non-shrinkable and crack-resistant. Operating temperature ranges from -70°C to +130°C.
TECHNICAL SPECIFICATIONS
INSTRUCTIONS FOR USE

TECHNICAL SPECIFICATIONS

Consumption (per 1 coat): manual application of about 1.7 kg/m2 per 1 mm of thickness.
Drying time: 8-24 hours before further exposure, depending on the thickness of the layer at a temperature of +20 ° C and a relative humidity of 65%. As the temperature decreases, the drying time increases.
Storage and transportation: at a temperature not lower than +5°C in a tightly sealed container, protecting it from moisture, heat and direct sunlight. Single transportation is allowed during the winter period with freezing. Defrost in a warm room without mechanical or thermal effects. After complete defrosting, mix thoroughly before use.
The warranty period of storage is 36 months in the original unopened packaging.
Composition: latex, filler, technological additives, antifungal additives, water.

INSTRUCTIONS FOR USE

Application conditions: the surface must be free of grease (if necessary), dry and clean, the temperature of the surface, composition and air must be at least +8 ° C, and the relative humidity below 80%.
Surface preparation: before use, clean the substrate to a solid surface, dust-free.
Method of application: mix the dry and liquid components thoroughly with a mixer at low speed, until a homogeneous consistency. Depending on the tasks, the solution can be prepared in different consistencies. The amount of liquid component for preparation of mortar for repair purposes, in the form of plaster or for bulk application can vary from 5.6 kg to 6.2 kg.
Cleaning of tools: rinse the tool with water immediately after use.
Precautions: the product is fire- and explosion-proof, has no unpleasant odor. Do not mix with other paints and varnishes and solvents. Follow the standard precautions when working with paintwork.
ENVIRONMENTAL PROTECTION: Dispose of empty containers as household waste. Do not pour the remaining material into sewers and reservoirs.