TECHNICAL SPECIFICATIONS
Consumption: 0.5-1 kg/m2 of the seam surface with a layer thickness of 2 mm.
Consistency: Depending on the tasks, the mortar can be prepared in various consistencies from being applied with a brush to being applied to vertical surfaces as waterproofing plaster.
Pot life of the mixture: 40-60 minutes.
Drying time: 1 hour at (20±2)°C and relative humidity (65±5%), 3 hours before applying the next layer. The final solidification takes 2 days.
Application: Apply to the surface with a roller, brush or gun.
Storage and transportation: at a temperature not lower than 5 ° C in a tightly closed container, protecting from moisture, heat and direct sunlight. Single transportation is allowed during the winter period with freezing. Defrost in a warm room without mechanical impact. After complete defrosting, mix thoroughly with a mixer at low speed before use, while controlling the absence of sediment.
Precautions: avoid contact with eyes, rinse with plenty of water in case of contact, keep out of reach of children. Use rubber gloves to protect your hands.
The warranty period of storage is 36 months in the original unopened packaging.
Composition: acrylic dispersion, surfactant, defoamer, filler, thickener, pigment, antiseptic.
INSTRUCTIONS FOR USE
Application conditions: the surface must be free of grease (if necessary), dry and clean, the temperature of the surface, composition and air must not be less than +8 ° C, and relative humidity below 80%.
Surface preparation: clean the surface from loose old coatings, dirt, grease, and dust. Patch up surface defects. Porous substrates (aerated concrete, cinder blocks, etc.) should be pre-treated with a "Waterproofing Primer"; chalking surfaces should be treated with a "Strengthening" primer. Before applying waterproofing, it is necessary to exclude capillary penetration of moisture into the substrate, cement screeds must contain no more than 2% residual moisture, gypsum screeds — no more than 0.5%, plasters — no more than 1%, and heated grounds — not more than 0.3%.
Method of application: mix the composition thoroughly with a mixer at low speed before use. Apply to the surface with a roller, brush or gun from the side of the intended exposure to moisture or liquid. To achieve the specified waterproofing characteristics, the material should be applied in at least two layers with a consumption of at least 500 g/m2. To reinforce cracks and joints, use, for example, a masking bandage. The finished coating should not be subjected to mechanical influences that could damage the waterproofing layer.
Cleaning of tools: rinse the tool with water immediately after use. The dried material is removed only mechanically.
OCCUPATIONAL SAFETY AND HEALTH: avoid contact with eyes, rinse with plenty of water, and keep out of reach of children. To protect your hands, use rubber gloves.
ENVIRONMENTAL PROTECTION: Dispose of empty containers as household waste. Do not pour the remaining material into the sewer and;