BACK

High-strength putty with plastic effect

ADD
It is intended for sealing seams and joints between wood and mineral materials, for example, cracks between structures in window and door openings, defects on the surface of wood, seams and defects in plasterboard partitions, etc.
Properties: it has high adhesion to mounting foam. It is characterized by low shrinkage. When dried, it forms a plastic-like surface that is resistant to moisture. It has high compatibility and adhesion to different types of bases. Forms a strong elastic coating. It is resistant to environmental influences. It can be combined with both organo-soluble and water-soluble paints.
TECHNICAL SPECIFICATIONS
INSTRUCTIONS FOR USE

TECHNICAL SPECIFICATIONS

Consumption per 1 coat is 1-1.2 kg/m2 with a layer thickness of 1 mm. Consumption depends on the terrain
grounds
Method of application: Apply with a grater, trowel or spatula in a layer of 1-3 mm.
Drying time before the next stage of work: 8-24 hours.
Storage and transportation: at a temperature not lower than +5°C in a tightly sealed container, protecting it from moisture, heat and direct sunlight. Single transportation is allowed during the winter period with freezing. Defrost in a warm room without mechanical impact. After complete defrosting, mix thoroughly with a mixer at low speed before use.
The warranty period of storage in the original unopened packaging is 3 years.
Composition: acrylic dispersion, water, ground marble, antiseptic, technological additives.

INSTRUCTIONS FOR USE

Application conditions: the surface to be treated must be dry and clean, the temperature of the surface, putty and air must be at least +8 ° C, and the relative humidity below 80%.
Pre-preparation: Pre-preparation Before application, clean the substrate to a solid surface. Absorbent and brittle surfaces should be treated, for example, with "Strengthening" TLN Ceramic primer, followed by "Deep penetration" TLN Ceramic. Standard strong surfaces should be primed with "Universal" TLN Ceramic or "Deep Penetration" TLN Ceramic to increase adhesion and eliminate surface compatibility issues.
Application: mix thoroughly with a mixer at low speed before use, while controlling the absence of sediment. Apply with a grater, trowel or spatula in a layer of 1-3 mm. If necessary, sand the resulting irregularities after the material has completely dried. Apply the second and subsequent layers when the previous layer is completely dry. Before applying the finishing coat to the "High-strength putty with the effect of plastic Profi" TLN Ceramic, priming is optional.
Cleaning of tools: Rinse the tool with water immediately after use. The dried material is removed only mechanically.
OCCUPATIONAL SAFETY: fire and explosion-proof, has no unpleasant odor. Do not mix with other paints, impregnations and solvents. Avoid contact with eyes, rinse with plenty of water in case of contact, keep out of reach of children. Use rubber gloves to protect your hands.
ENVIRONMENTAL PROTECTION: Dispose of empty containers as household waste. Do not pour the remaining material into sewers and reservoirs.