TECHNICAL SPECIFICATIONS
Consumption per 1 coat is 2-4 kg/m2 (coarse).
Consistency: Thick sour cream with solid inclusions
Granularity: Up to 2.5 mm (coarse)
Diluent: Water, no more than 5% by volume
Method of application: It is applied with a grater, trowel, spatula or cartouche gun. It is recommended to use a plastic grater to decorate the material. Bark beetle rubbing in order to obtain grooves begins 10-15 minutes after application. The direction of rubbing depends on the desired decorative effect.
Drying time at (20±2)°C and relative humidity (65±5)% From 8 to 24 hours, depending on the thickness of the layer. Subsequent painting (if necessary) is carried out after complete drying, but not earlier than after 8 hours.
Color: Ivory.
Storage and transportation: At a temperature not lower than +5°C in a tightly sealed container, protecting it from moisture, heat and direct sunlight. Single transportation is allowed during the winter period with freezing. Defrost in a warm room without mechanical impact. After complete defrosting, mix thoroughly with a mixer at low speed before use.
Tinting: In the factory in any shade. Independently in unsaturated tones with universal tinting pastes and water-based paints. The total amount of color paste is not more than 5%. With machine tinting, color matching is not guaranteed.
The warranty period of storage in the original unopened packaging is 3 years.
Composition: Acrylic dispersion, water, ground Baikal marble, antiseptic, technological additives.
INSTRUCTIONS FOR USE
Application conditions: The substrate must be dust-free and grease-free, the surface temperature, decorative plaster and air temperature must not be lower than +8 ° C, and the relative humidity must not exceed 80%
Pre-preparation: Clean the substrate to a solid surface before use. Smooth surfaces (plasterboard, plastic, chipboard) should be pre-treated with "Pigmented" primer. Remove or sand old enamel coatings before applying Bark Beetle. Priming is not required for weakly absorbent substrates. It facilitates the application by pre-moistening the surface with water or acrylic primer from a hand spray gun.
Cleaning of tools: Rinse the tool with water immediately after use.
OCCUPATIONAL SAFETY: Plaster is fire- and explosion-proof, has no unpleasant odor. Do not mix with other paints, impregnations and solvents. Avoid contact with eyes, rinse with plenty of water in case of contact, keep out of reach of children. Use rubber gloves to protect your hands.
ENVIRONMENTAL PROTECTION: Dispose of empty containers as household waste. Do not pour the remaining material into sewers and reservoirs.