TECHNICAL SPECIFICATIONS
Consumption per 1 coat is 1-3 kg/m2, depending on the relief being created.
Consistency: Thick sour cream with small granules
Granularity: Up to 1 mm
Diluent: Water
Method of application: It is applied with a grater, trowel, spatula or cartouche gun.
Drying time at (20±2)°C and relative humidity (65±5)% From 8 to 24 hours, depending on the thickness of the layer. Subsequent painting (if necessary) is carried out after complete drying, but not earlier than after 8 hours.
Color: Ivory (Quartz), White (Marble)
Storage and transportation: At a temperature not lower than +5°C in a tightly sealed container, protecting it from moisture, heat and direct sunlight. Single transportation is allowed during the winter period with freezing. Defrost in a warm room without mechanical impact. After complete defrosting, mix thoroughly with a mixer at low speed before use.
Tinting: In the factory in any shade. Independently in unsaturated tones with universal tinting pastes and water-based paints. With machine tinting, color matching is not guaranteed. In some cases, it is more appropriate to surface paint in the required color with tinted acrylic paint, for example, "Facade".
The warranty period of storage in the original unopened packaging is 3 years.
Composition: Acrylic dispersion, water, ground marble, antiseptic, technological additives.
INSTRUCTIONS FOR USE
Application conditions: The substrate must be dust-free and grease-free, the surface temperature, paint and air temperature should not be lower than +8 ° C, and the relative humidity should not exceed 80%.
Preliminary preparation: Clean the surface from loose old coatings, dirt and dust. Smooth surfaces (drywall, plastic, chipboard) are recommended to be pre-treated with "Pigmented" primer. Remove or sand the old enamel coatings before applying the "Fur Coat". Priming is not required for weakly absorbent substrates.
Decoration: Applied with a grater, trowel, spatula or cartouche gun. It is recommended to use a short-pile roller to decorate the material. The length of the "pile" of the "Fur coat" depends on the thickness of the layer and the length of the pile of the roller. 10-15 minutes after application, to give a less aggressive relief, the "pile" of the "Fur Coat" can be smoothed with a spatula or a pressure roller.
Cleaning of tools: Rinse the tool with water immediately after use.
OCCUPATIONAL SAFETY: The composition is fire- and explosion-proof, has no unpleasant odor. Do not mix with other paints, impregnations and solvents. Avoid contact with eyes, rinse with plenty of water in case of contact, keep out of reach of children. Use rubber gloves to protect your hands.
ENVIRONMENTAL PROTECTION: Dispose of empty containers as household waste. Do not pour the remaining material into sewers and reservoirs.