TECHNICAL SPECIFICATIONS
Consumption per 1 coat is 1-3 kg per 1 m2, depending on the relief being created.
Minimum layer thickness (mm): 1.
Maximum layer thickness (mm): 3.
Grain size (granulation): 1 mm marble.
Surface type: it can be applied to concrete, cement and gypsum plasters and putties, bricks, plasterboard panels, plastic, extrusion PPS, plywood, OSB and chipboard, surfaces previously painted with water-dispersion and other types of paints (except silicone) that firmly adhere to the surface.
Method of application: Apply with a grater, trowel, spatula or cartouche gun.
Drying time at (20±2)°C and relative humidity (65± 5)% drying time between two coats is 8 hours; before complete drying, 8-24 hours.
Storage and transportation: at a temperature not lower than +5°C in a tightly sealed container, protecting it from moisture, heat and direct sunlight. Single transportation is allowed during the winter period with freezing. Defrost in a warm room without mechanical impact. After complete defrosting, mix thoroughly with a mixer at low speed before use.
The warranty period of storage in the original unopened packaging is 3 years.
Composition: acrylic dispersion, water, ground marble, antiseptic, technological additives.
INSTRUCTIONS FOR USE
Application conditions: the surface to be treated must be dry and clean, the temperature of the surface, decorative plaster and air must be at least +8 ° C, and the relative humidity below 80%.
Pre-preparation: clean the substrate to a solid surface before use. Surface defects should be patched with putty. Smooth surfaces (drywall, plastic, chipboard) should be pre-primed with "Pigmented" TLN Ceramic. Remove or sand the old enamel coatings before applying the "Fur Coat". Priming is not required for weakly absorbent substrates.
Method of application: mix thoroughly before use, controlling the absence of sediment. Apply with a grater, trowel, spatula or cartouche gun. It is recommended to use a short-pile roller to decorate the material. The length of the "Fur Coat" pile depends on the thickness of the layer and the length of the roller pile. 10-15 minutes after application, to give a less aggressive relief, the pile of the "Fur Coat" can be smoothed with a spatula or a pressure roller.
Cleaning of tools: Rinse the tool with water immediately after use.
OCCUPATIONAL SAFETY: The composition is fire- and explosion-proof, has no unpleasant odor. Do not mix with other paints, impregnations and solvents. Avoid contact with eyes, rinse with plenty of water in case of contact, keep out of reach of children. Use rubber gloves to protect your hands.
ENVIRONMENTAL PROTECTION: Dispose of empty containers as household waste. Do not pour the remaining material into sewers and reservoirs.